Watts 650 00AP - Manual (Page 2)

Fig. No. 650003
Basin Lavatory Legs for China Basin
Installation Instructions
1. Press in threaded top plug (2) into the hexagonal leg (1).
2. Press in pointed bottom plug (3) into other end of
hexagonal leg (1).
3. Thread on square nut (6) onto one end of threaded rod (4)
approximately 1 1 ⁄
2
" from end of rod or as required.
4. Slip on round washer (5) over end of rod (4) and thread rod
into threaded top plug (2).
5. Press on rubber has washer (7) onto other open end of
threaded rod (4).
6. Slide on hex bell escutcheon (8) onto hex leg (1) with round
diameter facing upward and screw (9) facing side of hex
leg (8).
7. Place completed leg assembly under the china basin.
Make sure that rubber hat washer (7) fits into the hole on
the under-side of sink. Thread up the threaded rod (4) until
there is sufficient tension on the hex leg (1).
8. Thread down square nut (6) and round washer (5) to lock
assembly securely in place.
9. Bring up hex bell escutcheon (8) to cover exposed rod and
tighten screw (9).
10. Repeat the same steps on the second leg.
NOTE: When installing legs over a smooth tile floor, it is sug-
gested that you drill a small diameter hole into the tile to permit
the pointed end of the bottom plug (3) to anchor itself to the
floor to prevent sliding.
7
8
6
5
9
2
4
1
3
Limited Warranty: Watts Regulator Co. (the “Company”) warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of
original shipment. In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER
WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special
or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting
from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no
control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the above
limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws to
determine your rights. SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.
IS-65000AP/650003 0904 EDP# 1916062 © Watts, 2009
USA: 815 Chestnut St., No. Andover, MA 01845-6098; www.watts.com
Canada: 5435 North Service Rd., Burlington, ONT. L7L 5H7; www.wattscanada.ca
B r a s s & T u b u l a r P r o d u c t s