Watts DWB - Manual

Model 2M2 DWB
Duo-Clozure
™ Washing Machine Wall Box
Installation Instructions
Description
The Watts Model 2M2 DWB Duo-Clozure Washing Ma-
chine Wall Box (Fig. 1) consists of a molded plastic enclo-
sure with top and side knockouts that accept the hot and
cold water supply piping as well as a 1
1 ⁄
2
” and 2” drain
knockout to accommodate the waste drain pipe. The
Duo-Clozure also comes with mounting straps for secur-
ing the box to wall studs. The Duo-Clozure incorporates
a Watts Model 2M2 Duo-Cloz™ Washing Machine Shutoff
valve that simultaneously controls the fl ow of both hot
and cold water to the appliance. The Duo-Clozure trim
plate can be decorated to blend in with the wall fi nish.
Installation
CAUTION: Be sure to install the Duo-Clozure so that the
“On-Off” lever is above the top of the washing machine.
1. Determine the location to install the Watts Duo-Clozure
wall box, Fig. 2. Be sure that the Duo-Cloz valve lever
is located above the top of the washing machine and is
accessible to operate the valve.
(Suggested minimum height from the bottom of the
mounting straps to the fi nished fl oor is 41 inches,
Fig. 3.)
Figure 1
Figure 3
Figure 2
Finished Wall
10 3 ⁄
16
" Min.
2 1 ⁄
2
"
Min.
2 1 ⁄ 2 "
6" Max
5 3 ⁄
16
" Min.
3 ⁄
4
" Typical
IS-2M2 DWB
Finished Floor
Mounting Strap
42" Min.
To Box
Centerline
41" Min.
To Bottom
of Bracket
IS-2M2 DWB.indd 1 9/24/08 9:09:35 AM