Watts WP26P-12PB - Manual

Poly-Alloy Swivel Couplings are used for connective 3 ⁄
8
" or 1 ⁄
2
"
WaterPEX ® supply lines directly from the manifold or branch
supply to the faucet. (Not needed if using WaterPEX ® Risers or
Flexible Risers.)
Specification
System shall be plumbed using Watts WaterPEX ® cross-linked
polyethylene pipe, and all joints shall be made using Watts
brass CrimpRing™ and /or poly-alloy CrimpRing™ fittings
using either the Watts copper CrimpRing™ or stainless steel
CinchClamp™** crimping methods as outlined in the Watts
WaterPEX ® ‚ Installation Guidelines.
Installation Note
Couplings must be installed in accordance with all Watts
WaterPEX ® installation procedures, including information
provided in the WaterPEX ® installation manual and guidelines.
Approvals
• Manufactured in accordance with American Society for
Testing and Material (ASTM) F-877 and F-2159
• Listed by the National Sanitation Foundation to NSF
Standards 14 and 61 for use in potable water systems.
• Listed by NSF to be in compliant to the Uniform Plumbing
Code
• Labeled B137.5 which indicates that it is compliant to the
CSA standards B137.5
• Manufactured from Acudel ® engineered thermoplastic resin.
For Residential and Commercial Applications
ES-WP-PASwivel
Job Name ––––––––––––––––––––––––––––––––––––––––––– Contractor ––––––––––––––––––––––––––––––––––––––––––––
Job Location ––––––––––––––––––––––––––––––––––––––––– Approval –––––––––––––––––––––––––––––––––––––––––––––
Engineer ––––––––––––––––––––––––––––––––––––––––––––– Contractor’s P.O. No. ––––––––––––––––––––––––––––––––––
Approval ––––––––––––––––––––––––––––––––––––––––––––– Representative ––––––––––––––––––––––––––––––––––––––––
WP25P (straight) WP26P (angle)
WaterPEX ® Poly-Alloy
Swivel Couplings
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
LEAD FREE
*
Warning!
If connections must be made in temperatures below 30°F,
caution must be taken to allow the WaterPEX to form a proper
seal against the barb. Apply the connection slowly to ensure
the PEX material conforms to the barb.
* The wetted surface of this product contacted by consumable
water contains less than one quarter of one percent (0.25%) of
lead by weight.
** Note: Watts WaterPEX CinchClamp ™ fittings should not be used
with wrot copper PEX fittings.