Watts RL600 - Manual

RL 600
IS-RL 600
Instructions for Installing Flippen RL 600
Automatic Livestock Watering Kit
Assembly and Reordering Instructions
To Reorder
paRt paRt No. oRdeRiNg code No.
Complete Assembly RL 600 0780105
Universal Tank Adaptor (Not shown) UA600 0780245
Arm and Seat RL 600A 0780173
Nuzzle and Arm Assembly RL 600V 0780174
Stem and Chain Assembly RL 600 SC 0780365
Garden Hose Adaptor (Not shown) AP-112 0780242
Installation Instructions:
1. Remove bulkhead fitting from tank, reverse so drain plug
faces into tank, and reinstall.
2. Remove drain plug from bulkhead fitting and install valve
assembly. Hand tighten.
3. Attach brass valve arm to plastic valve arm with thumbscrew
provided. Make sure serrations mesh properly.
4. Attach threaded end of stem to the brass valve arm.
5. Attach float ball to threaded screw at end of chain. The float
is self tapping.
6. Using Teflon tape to seal threads, connect 1/2" tapered pipe
supply line to inlet side of valve. Do not use pipe dope or sol-
vent cement. Use an AP-112 fitting for garden hose connec-
tion.
7. Adjust float level to desired height by changing angle of brass
arm.
8. Maximum pressure - 75 psi.
9. Maximum temperature - 140°F
Parts and Installation Instructions
Parts Included with Kit:
Plastic Valve Assembly
Brass Valve Arm
Thumbscrew
Stem/Chain Assembly
6" Float Ball
Parts Not Included with Kit:
Teflon ® Sealing Tape
AP-112 Garden Hose Connector (if connecting to a garden hose)