Watts Fleck 2750 Brass Valve - Manual (Page 2)

Job Specification Sheet.......................................................................................................................................... 3
General Commercial Pre-Installation Check List.................................................................................................... 4
3200 Timer Setting Procedure................................................................................................................................ 5
3210 Timer Settings............................................................................................................................................... 6
3200 & 3210 Timer Series Regeneration Cycle Program Setting Procedure......................................................... 7
3200 Timer Assembly............................................................................................................................................. 8
3210 Timer Assembly........................................................................................................................................... 10
Control Drive Assembly........................................................................................................................................ 12
Control Valve with 1700 Injector........................................................................................................................... 14
1600 Series Brine System Assembly................................................................................................................... 16
1700 Series Brine System Assembly................................................................................................................... 17
1” Meter Assembly................................................................................................................................................ 18
2310 Safety Brine Valve....................................................................................................................................... 19
Service Valve Operator......................................................................................................................................... 20
Troubleshooting.................................................................................................................................................... 21
General Service Hints for Meter Control.............................................................................................................. 22
Water Conditioner Flow Diagrams........................................................................................................................ 23
Flow Data & Injector Draw Rates......................................................................................................................... 25
System #4 Typical Tank Installation with Optional Meter...................................................................................... 26
System #5 Interlock Typical Twin Tank Installation with Optional 2 Meter Interlock and .
No Hard Water Bypass......................................................................................................................................... 26
System #6 Twin Series Regeneration Installation with a Remote Meter.............................................................. 27
System #7 Twin Alternator Installation with a Remote Meter............................................................................... 27
System #4 Immediate & Delayed Valve Wiring.................................................................................................... 28
System #4 Remote Signal Start Valve Wiring...................................................................................................... 29
System #5 Duplex Valve Wiring........................................................................................................................... 30
System #6 Duplex Valve Wiring........................................................................................................................... 31
System #7 Duplex 24V/120V 3-Way Valve Wiring............................................................................................... 32
System #7 Duplex 230V 3-Way Valve Wiring....................................................................................................... 33
Service Assemblies.............................................................................................................................................. 34
Table of Contents
IMPORTANT PLEASE READ:
The information, specifications and illustrations in this manual are based on the latest information available at the time of
printing. The manufacturer reserves the right to make changes at any time without notice.
This manual is intended as a guide for service of the valve only. System installation requires information from a number of
suppliers not known at the time of manufacture. This product should be installed by a plumbing professional.
This unit is designed to be installed on potable water systems only.
This product must be installed in compliance with all state and municipal plumbing and electrical codes. Permits may be
required at the time of installation.
If daytime operating pressure exceeds 80 psi, nighttime pressures may exceed pressure limits. A pressure reducing valve must
be installed.
Do not install the unit where temperatures may drop below 32°F (0°C) or above 125°F (52°C).
Do not place the unit in direct sunlight. Black units will absorb radiant heat increasing internal temperatures.
Do not strike the valve or any of the components.
Warranty of this product extends to manufacturing defects of the vessel and controller, not the membrane. Misapplication of this
product may result in failure to properly condition water, or damage to product.
A prefilter should be used on installations in which free solids are present.
In some applications local municipalities treat water with Chloramines. High Chloramine levels may damage valve components.
Correct and constant voltage must be supplied to the control valve to maintain proper function.
•
•
•
•
•
•
•
•
•
•
•
•