Watts WPCCT-6 - Manual

For Residential and Commercial Applications
ES-WP-WPCCT-6
Job Name ––––––––––––––––––––––––––––––––––––––––––– Contractor ––––––––––––––––––––––––––––––––––––––––––––
Job Location ––––––––––––––––––––––––––––––––––––––––– Approval –––––––––––––––––––––––––––––––––––––––––––––
Engineer ––––––––––––––––––––––––––––––––––––––––––––– Contractor’s P.O. No. –––––––––––––––––––––––––––––––––––
Approval ––––––––––––––––––––––––––––––––––––––––––––– Representative ––––––––––––––––––––––––––––––––––––––––
Ratcheting CinchClamp™ Tool with work pouch and calibration gauge.
Calibration gauge is located in side pouch.
Model desCRipTion
WPCCT-6 Ratcheting CinchClamp™ Tool
Model WPCCT-6
Ratcheting CinchClamp™ Tool
Sizes: 1 ⁄
2
", 5 ⁄
8
", 3 ⁄
4
", 1" (15, 18, 20, 25mm)
Watts Ratcheting CinchClamp™ Tool is designed to be used
with WaterPEX tubing and CinchClamp™ connections.
Specifications
Connections shall use Watts brass and poly-alloy crimp fittings
and WaterPEX ® cross-linked polyethylene pipe.
Installation
All CinchClamps must be installed using a Watts CinchClamp
Tool and in accordance with all installation guidelines.
– Make sure the WaterPEX has a clean, square cut end.
– Slide the CinchClamp over the WaterPEX.
– Insert fitting and position CinchClamp, allowing for approxi-
mately 1 ⁄
8
" clearance between clamp and fitting.
– Position the open jaws of the CinchClamp™ Tool over the
tabs of the CinchClamp and squeeze. Allow the tool to ratch-
et to the next position. Repeat until the white indicator is
completely visible in the view hole (approximately seven
times).
– To release the CinchClamp Tool rotate the release lever on the
side. It is very important to complete the cinch process
before releasing the tool.
If connections are made in temperatures below 30°F,
caution must be taken to pause between ratchets, allow-
ing the WaterPEX to form a proper seal against the barb.
Do not use the Ratcheting CinchClamp Tool to remove
CinchClamps. This will cause damage to the tool,
resulting in improper connections.
Standards
– Watts CinchClamps are manufactured in accordance with the
American Society for Testing and Materials (ASTM) F-2098.
– Watts fittings are manufactured in accordance with the
American Society for Testing and Materials (ASTM) F-1807,
F-2159, and F-2434.
Holster
Ratcheting
CinchClamp™ Tool
View Hole
Gauge
Release lever
Gauge
pouch
Model WpCCT-6
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.