Watts LFFBV-3-Press - Manual

Series FBV-3-Press and
LFFBV-3-Press Ball Valve
for Water Service
Sizes: 1 ⁄
2
" – 2" (15 - 50mm)
Installation Instructions
The FBV-3-Press and LFFBV-3-Press ball valve is designed for use with Types K, L,
and M Hard Copper Tubing sizes 1 ⁄
2
" to 2" (15-50mm) and Soft Copper Tubing sizes
1 ⁄
2
" to 1 1 ⁄
4
" (15-32mm).
Warning: Please read and understand the following instructions for installing
FBV-3-Press and LFFBV-3-Press ball valves. Failure to follow all instructions may result
in extensive property damage or serious injury.
1. Square cut copper tubing at right angle, using a displacement type cutter.
2. To prevent cutting the O-ring, carefully deburr the internal and external surfaces of
the tube end.
3. The tubing is now ready to insert into the ball valve. Do not use oils or lubricant on
the valve or tube. This will degrade the FBV-3-Press and LFFBV-3-Press EPDM.
4. Slowly rotate the valve while sliding the valve onto the tubing. Insert to the fitting
stop. The end of the tubing must be fully inserted and contact the stop.
5. Mark the insertion depth on the tubing at the point where tubing meets valve body.
6. Using an appropriate pressing tool, place the jaw on the valve fitting. Check the
insertion mark on the tubing to be sure that the tubing is against the valve stop.
7. Begin creating the press connection. Depress the tool trigger until the jaw has
crimped the valve fitting.
8. When the press connection is complete, the jaw can be opened and removed
from the valve fitting.
9. When all system joints are complete, pressure testing is to be carried out in
accordance with local codes.
IS-FBV-3Press.5-2
1
3
5
7
9
2
4
6
8
Limited Warranty: Watts Regulator Co. (the “Company”) warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of
original shipment. In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER
WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special
or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting
from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no
control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the above
limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws to
determine your rights. SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.
IS-FBV-3Press.5-2 1114 EDP# 2915018 © 2011 Watts
USA: No. Andover, MA • Tel. (978) 688-1811 • Fax: (978) 794-1848 • www.watts.com
Canada: Burlington, ON • Tel. (905) 332-4090 • Fax: (905) 332-7068 • www.wattscanada.ca
A Watts Water Technologies Company