Watts TRCU-M1 - Manual (Page 13)

11
Assembly
Attach Power Cord
Operating Instructions
• BEFORE each use carefully check the
condition of the equipment . Do not use
if damaged in any way . Do not use if any
parts are missing .
• Review the equipment assembly and
make sure all connections are proper and
secure .
• Inspect the Power Cord and plug, confirm
that the electrical outlet is the correct
rating and properly grounded, and test
operation of GFCI plug .
• Make sure that work area is clean, well
lit, free of clutter, with no distractions, and
accessible only by authorized personnel
and workers .
• Make sure the Control Unit is firmly on the
ground or other stable work surface . Do
not place on ladder or shelf .
NOTICE
Make sure power (On/Off) switch on
Control Unit is in Off position.
WARNING
!
BEFORE each use review
this Manual, especially
the Important Safety
Information. Do not use the
equipment unless you are familiar with
safe and proper operation.
Equipment Setup & Usage Instructions
Attach Fuser
NOTE: Fusers for use with TRITON are sold separately.
• Push the other end of the Fuser Cord
onto the selected Fuser as shown . Make
sure the jaws on the Fuser are closed .
Attach Fuser Cord
• Locate the Fuser Cord. The Fuser Cord
has connectors on each end .
• Locate the Fuser Cord terminal on the
side of the Control Unit . Push one end of
Fuser Cord securely into terminal .
• Locate the Power Cord. The Power Cord
has a GFCI plug on one end and a female
connector on the other end .
• Locate the Power Cord receptacle on the
Control Unit .
• Insert the female end of the Power Cord
into the Power Cord receptacle on back
of unit as shown . Push female end of
Power Cord into receptacle securely .
STEP 1
STEP 2
STEP 3