E-flite Tribute FX 3D ARF - Manual (Page 10)

10 E-flite Tribute Fx 3D ARF Assembly Manual
  8. Slide the linkage wire through the control connector.
Center the aileron and use a 2mm x 4mm machine screw
to secure the linkage. Use threadlock on the screw to
prevent it from loosening during flight.
  9. Use side cutters to remove any excess wire extending
beyond the connector.
 10. Repeat Steps 1 through 9 for the remaining aileron
servo and linkage.
Wing and Stabilizer Installation
Required Parts
Wing Fuselage
Belly pan Stabilizer assembly
Required Tools and Adhesives
3 in (76mm) servo extension (2)
String Low-tack tape
T-pin Foam-safe CA (thick)
Foam safe accelerator
 1. Remove the canopy by lifting from the rear. A magnet
holds the canopy in position at the rear.