E-flite Tribute FX 3D ARF User Manual
Page 16
1
E-flite Tribute Fx 3D ARF Assembly Manual
4. Prepare the elevator and rudder servos by attaching 18
in (457mm) servo extensions to each servo. Drill a 1/16
in (1.5mm) hole in the outer hole in the servo arm. Install
a control connector in the long servo arms and secure
them using the control connector backplates. Use the radio
system to center the servos before attaching the servo arms
to the servo.
5. Install the elevator servo in the fuselage using hot glue.
Make sure the output of the servo faces toward the rear of
the fuselage.
6. Slide the control horn through the pre-cut slot
in the elevator. The shoulder on the horn rests tight
against the elevator.
7. Slide the control horn backplate down on the control
horn from the top side of the elevator. The backplate
rests tight against the elevator. Use foam-safe CA on the
backplate to complete the control horn installation.