E-flite Piper Pawnee 15e ARF - Manual (Page 10)

10 E-flite Piper Pawnee ARF Assembly Manual
 5. Slip the tire over the rear hub. Insert the front hub
into the tire. Place a piece of music wire or hex wrench
through a hole in the front hub and into a screw hole in
the rear hub to help align the holes when inserting the
front hub in the wheel.
 6. Use four 2mm x 15mm sheet metal screws and a #1
Phillips screwdriver to secure the front and rear hubs. You
can now install the hubcap onteh wheel.
 7. Attach the landing gear covers to the landing gear
using four 2mm x 6mm machine screws. Make sure to
use threadlock on these screws. The front edge of the
covers will line up with the front edge of the landing gear
when installed correctly.