E-flite Piper Pawnee 15e ARF - Manual (Page 19)

19 E-flite Piper Pawnee ARF Assembly Manual
Flap Servo Installation
Required Parts
Wing panels (right and left)
Servo w/hardware (2)
Servo cover (right and left)
6-inch (152) servo extension (2)
2mm x 15mm machine screw (4)
2mm x 8mm self-tapping screw (8)
Control horn w/backplate (2)
Clevis (2)
Clevis retainer (2)
4-inch (102mm) pushrod wire (2)
Pushrod connector (2)
Servo mounting block
5/8 x 3/8 x 3/8-inch (16 x 9.5 x 9.5mm) (4)
Required Tools and Adhesives
Drill Thin CA
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
6-minute epoxy Pencil
Phillips screwdriver: #1 Felt-tipped pen
String Side cutters
Pin drill Hobby knife
Razor saw Covering iron
Sandpaper
Note: The installation of the flaps are optional. You will
need to purchase a Y-harness or use a computer radio
with mixing to operate the flaps.
 1. Plug the flap servos into the radio system and make
sure they operate and are centered as well.