E-flite Piper Pawnee 15e ARF - Manual (Page 38)

38 E-flite Piper Pawnee ARF Assembly Manual
 4. Remove the battery hatch from the fuselage. This is
accomplished by pushing the hatch forward and then
lifting the hatch up.
 5. Install the battery in the fuselage using the 8-inch
(204mm) hook and loop straps.
 6. Turn on the radio system and plug the battery into the
speed control. Use the throttle to check that the motor
rotates counterclockwise when viewed from the front. If
not, follow the directions included with your speed control
to change the direction of the motor rotation.
Important Information About Your Brushless ESC
Make sure your ESC brake is programmed to Off. Also,
be sure to use an ESC with the proper low-voltage cutoff
and it is set correctly for the batteries you are using.
Note: Never check the motor rotation on the bench
with the propeller installed. The plane could move and
cause serious injury. Always check the motor without the
propeller to avoid injury.
 7. Cut and tape a piece of card stock on both sides of
the fuselage to indicate the front edge of the fuselage.