GBC Auto 50 MBM Crease - Manual (Page 19)

Programming Screen
This screen allows you to set up to 29 different positions of crease on each document.
Line 1 shows which crease line is being programmed and what its current value is in mm.
Line 2 shows the operator if they are working in Absolute or Incremental.
Line 3 shows which line of the current program is being worked on and what increments
are being used, 1mm or 0.1mm.
To switch between increments, press the X button. It is advised that whole mm are
programmed before tenths.
Line 4 has arrow functions, UP for Increasing the value, DOWN for Decreasing the
value, LEFT to go Back to the previous screen and RIGHT to advance to the Next crease.
When the last crease position has been programmed, press the RIGHT button and then
the TICK button to save the settings to memory.
The display will automatically return to the Operator Run Screen in order to commence
the job. The sheet counter will also be reset to zero.
Alterations to a previously programmed job are achieved by indexing through the
program until the required field is reached, changing the settings and saving the new
settings.
19