GunVault TVB 4810 - Manual (Page 10)

P a g e | 9
SecuRam Biometric Lock (TVB 4810 Only) – Continued…
Deleting All Fingerprints
Important: Only the administrator finger prints can initiate the deletion process.
Step 1: Press the button above the fingerprint sensor and swipe the administrator’s finger from top to the bottom.
Step 2: While the green LED flashes, push the button above the fingerprint sensor three (3) times.
Step 3: The green and red LEDs will flash alternately indicating all fingerprints have been deleted.
Maintenance
Important: All maintenance work should be performed by a qualified locksmith in your area. Cannon assumes no
responsibility for the cost of maintenance or the work performed.

Low Battery Warning: If the yellow LED flashes three (3) times with three (3) long beeps after a valid fingerprint
read, the battery is low. Only use Duracell 9 Volt Alkaline batteries with a ‘Best if Used by Date’ 5 years in the
future.

Changing the Battery: Turn the brass/chrome housing ring counterclockwise and pull off. Install new battery and
reinstall brass/chrome housing ring. Hint: Align the three groves on the housing ring with the three groves on the
keypad and turn clockwise.