GunVault TVB 4810 - Manual (Page 9)

P a g e | 8
SecuRam Biometric Lock (TVB 4810 Only)
How to Open the Unit
Important: The TVB 4810 does not have a preset passcode. The biometric lock is shipped with no fingerprint and will open
after pressing the button above the gold colored finger print sensor on the keypad.
See the ‘ID My Lock’ section before beginning (Pg. 5).
Step 1: Turn the handle slightly clockwise until handle stops. Do not force it!
Step 2: Press the button above the fingerprint sensor and swipe the programmed finger from top to the bottom. If
no fingerprint is programmed, press the button above the fingerprint sensor to open.
Step 3: Turn handle counter-clockwise to unlock Unit.
If there’s a long beep with multiple red LED flashes, the fingerprint was not accepted. Slow down and start over.
Programming Instructions
Important: When enrolling fingerprints, ensure the door is in the open and locked position. The first two (2) enrolled
fingerprints are administrators and can add additional users.
Initial Enrollment (No user prints are enrolled in the lock):
Step 1: Press the button above the fingerprint sensor. A green LED will be flashing.
Step 2: Press and hold the button above the finger sensor until the green and red LED are both on.
Step 3: Slide your finger from the top to the bottom of the fingerprint sensor bar. The red LED will flash once with
a beep.
Step 4: Slide your finger from the top to the bottom of the fingerprint sensor bar. When the red and green LEDs
turn off with two (2) beeps, it means the first fingerprint is enrolled.
Enrollment of Additional Fingerprints (Only ten (10) fingrprints can be enrolled into the lock):
Step 1: Open the unit using an Administrator fingerprint
Step 2: While the green LED flashes, press and hold the button above the fingerprint sensor until there’s two (2)
beeps and the green LED turns off.
Step 3: Press the button above the fingerprint sensor, the red and green LED will turn on.
Step 4: Slide your finger from the top to the bottom of the fingerprint sensor bar. The red LED will flash once with
a beep.
Step 5: Slide your finger from the top to the bottom of the fingerprint sensor bar. When the red and green LEDs
turn off with two (2) beeps, it means the fingerprint is enrolled.