GunVault TVB 4810 - Manual (Page 7)

P a g e | 6
SecuRam Non Biometric Lock (TV 4810 Only)
(top row of number are 1,2,3,4 and a ‘SecuRam’ logo on the faceplate)
How to Open the Unit
Important: The factory preset code is 1,2,3,4,5,6 and should be changed before using the Unit. It is the owners’ responsibility
to maintain the code; Cannon will try to maintain records for up to 6 months. Multiple electronic locks are used, each with
different operating instructions.
See the ‘ID My Lock’ section before beginning (Pg. 5).
Step 1: Turn the handle slightly clockwise until handle stops. Do not force it!
Step 2: Enter the six (6) digit code slowly.
Step 3: Turn handle counter-clockwise to unlock Unit.
If there are three (3) beeps after entering the code the lock doesn’t recognize the code. Slow down and start over.
Programming Instructions
Important: When changing the combination door must be in the open and locked position. You must know the current six (6)
digit code to program and take 20 seconds to complete steps 1-4.
Step 1: Enter '0' six (6) times
Step 2: Enter existing six (6) digit code
Step 3: Enter new six (6) digit code
Step 4: Re-enter new six (6) digit code
If lock signals three (3) times, then the former code is still valid.
Lock Out (Wrong Try Penalty)
After four (4) wrong entries the lock will go into lock out for 5 minutes. Lock can also go into lockout during re-programming
if it interprets an incorrect programming sequence.
Do not press any buttons or unplug the battery during the lockout period.
It will restart the 5 minute waiting period.
Using the Night Light
To activate the light, press the ‘ ‘ button on the keypad before entering the code.
Maintenance
Important: All maintenance work should be performed by a qualified locksmith in your area. Cannon assumes no
responsibility for the cost of maintenance or the work performed.

Low Battery Warning: The lock will repeatedly beep during unlocking indicating that the battery is low and needs to
be replaced. Only use Duracell 9 Volt Alkaline batteries with a ‘Best if Used by Date’ 5 years in the future.

Changing the Battery: Turn the brass/chrome housing ring counterclockwise and pull off. Install new battery and
reinstall brass/chrome housing ring. Hint: Align the three groves on the housing ring with the three groves on the
keypad and turn clockwise.