GunVault TVB 4810 - Manual (Page 11)

P a g e | 10
Unit Setup
Removing Unit from Pallet
GunVault recommends contacting professional movers to install your Unit.
By choosing to install the Unit on your own you agree to hold GunVault blameless
of any damage, injury, or death caused by your negligence.
Proceed with caution.
Use Caution. Unit is top heavy. While having someone(s) securely holding the Unit:

Open door, remove the 2 lag screws from the floor area (opposite corners).

Close door. If equipped with a mechanical lock turn dial back to zero and lock with key.

With at least two (2) people, carefully slide the Unit from pallet.
Placement of the Unit
Before placing your Unit, verify the load bearing weight of the floor or stairs the Unit will be moved over (tile, wood, and
other types of floors could be damaged by the weight of the Unit). To help determine if the Unit will make it through
doorways, stairs, or corners use the empty Unit box to see if it will fit all the way to the final location.
When choosing a location consider the following:

Install the Unit near a load-bearing wall as a precaution to support the weight.

To protect the exterior finish, consider installing the Unit inside your home where there’s climate control.

Where the Unit is placed will have a big impact on how it will perform during a fire. Consider lower levels (1
st
floor
or basement) where temperatures tend to be cooler and try to stay away from potential hot spots (areas where
flammable materials are stored).
Anchoring of the Unit
Anchoring the Unit to the floor is highly recommended. To help eliminate rust issues there should be a gap between the Unit
and floor to allow air flow (treated wood shims are recommended). Before leveling the Unit, make sure the Unit is
square/level. Use the appropriate hardware for the wood or cement surface the Unit is anchored too; anchoring hardware
can be purchased from a local hardware store (not included). After the Unit is anchored use the four or two black floor plugs
(depending on Unit) to cover the anchoring holes inside the Unit.
Interior Set-Up
The top shelf of the TV 4810 and TVB 4810 is fixed and cannot be adjusted.
Installing the Foam Rifle Rack:
Important: Before installing, determine the location/height by using the weapon(s) that will be stored in the unit. Double
check if the location/height is correct before installing. Because once the tap is removed and the Foam Rifle Rack is installed,
damage will occur if adjustments are needed.
Step 1: Determine the location/height of the Foam Rifle Rack.
Step 2: Clean the install area of all loose debris to insure a tight bond. If needed, rubbing alcohol can be used to
clean the area. Let the rubbing alcohol evaporate/dry before installing.
Step 3: Remove the tap on the Foam Rifle Rack.
Step 4: Carefully install the Foam Rifle Rack at the desired location and press the tap sides firmly into the units
body.