Kino Flo Image 80, 40 & 20 DMX - Manual (Page 5)

The Image 80 Fixture is used for example purposes throughout these
instructions.
5
E
G F E D A C B
A) Manual Selector Dial: Turns lamps on and off manually without
connecting DMX Cable to Fixture.
B) DMX Address: Sets DMX Address of Fixture.
C) Individual Lamp / Fixture Switch: Converts between
INDIVIDUAL LAMP and FIXTURE methods of DMX control.
D) DMX-In & DMX-Out: DMX-IN receives DMX signals from Dimmer
Board, DMX-OUT relays DMX signal through to other Fixtures or
Instruments.
E) DMX TERMINATE Switch: Terminates DMX signal at the end of
Fixture series.
F) Power Switch: Has a built-in indicator light, which can detect if AC
power is present in power cord. "O" = OFF position
G) Fuse: Provides circuit protection. Note: If Fuse is "blown" or
"open" replace with same type of fuse rating as marked.
IMPORTANT!
The dimmer board/light console should have its channel set to
LINEAR light output response. (LINEAR response is the default
setting on most dimmer boards.)