Briggs & Stratton 205051GS - Manual (Page 16)

16 BRIGGSandSTRATTON.COM
High Temperature (FC_7)
This fault is indicated by fault code FC_7 and seven blinks on
the LED indicator. The contacts of the coolant temperature
switch are normally open. If the engine coolant temperature
exceeds approximately 115.5°C (240°F), the fault is detected
and the engine shuts down.
Common causes for this condition include running the
unit with all access doors removed, obstructed air inlet or
exhaust port, low oil or coolant level, or debris in the engine
compartment or radiator.
To resolve the problem, let the engine cool down and remove
any accumulated debris and obstructions. Ensure that the
access doors are installed whenever the unit is running.
Transfer Switch Fault (FC_8)
This fault is indicated by fault code FC_8 and eight blinks on
the LED indicator (if transfer switch is equipped with fault
detection). The most likely cause of this fault is a blown fuse
in the transfer switch.
To remedy the problem, contact your installer or a Briggs &
Stratton Authorized Dealer.
Generator Maintenance
The generator warranty does not cover items that have been
subjected to operator abuse or neglect. To receive full value
from the warranty, the operator must maintain the system as
instructed in the engine operator’s manual.
All adjustments should be made at least once each season.
Follow the requirements in the engine operator’s manual.
Generator maintenance consists of keeping the unit clean.
Operate the unit in an environment where it will not be
exposed to excessive dust, dirt, moisture or any corrosive
vapors. Cooling air louvers on the enclosure must not
become clogged with snow, leaves, or any other foreign
material.
Check the cleanliness of the unit frequently and clean when
dust, dirt, oil, moisture or other foreign substances are
visible on its exterior/interior surface.
NOTE: DO NOT use direct spray from a garden hose to clean
generator. Water can enter the engine and generator and
cause problems.
Engine Maintenance
An engine manual was packaged with this system. Please
refer there for all engine-related maintenance topics.
However, proper engine cooling and lubrication are so
important we give them special mention here.
Engine Oil
The system is filled with the recommended non-synthetic oil
(API SL 10W-30W). This allows for system operation in a
wide range of temperature and climate conditions.
NOTE: Refer to the engine operator’s manual for
recommended oil change intervals.
Shown here is the oil drain location (B) and the oil filter (A).
Changing Engine Oil
CAUTION
Avoid prolonged or repeated skin contact with used
motor oil.
Used motor oil has been shown to cause skin cancer in
certain laboratory animals.
Thoroughly wash exposed areas with soap and water.
•
•
KEEP OUT OF REACH OF CHILDREN. DON’T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION CENTERS.
1. Disconnect the negative battery terminal from battery.
2. Change oil while the engine is still warm from running,
as described in the engine operator’s manual.
NOTICE
Any attempt to crank or start the engine before it has been
properly serviced with the recommended oil will result in
equipment failure.
Refer to Maintenance and engine manual for oil fill
information.
Damage to equipment resulting from failure to follow this
instruction will void engine and generator warranty.
•
•
To fill your engine with oil:
Follow the oil grade recommendation and oil fill instructions
given in the engine operator’s manual.
To make the task of adding oil more convenient, we
recommend use of a funnel attached to a length of tubing
long enough to reach from the Coolant Fill door to the oil fill
opening on the engine valve cover.
A
B