Reloop MIXAGE IE MK2 - Manual (Page 31)

ENGLISH
31
T26 Linefader
Regulates the respective channel‘s volume.
T27 Master volume dial (analog, not software)
The dial adjusts the master output‘s volume.
T28 phones dial (analog, not software)
The dial adjusts the headphones‘ volume.
T29 Cue Mix Fader
With the Cue Mix Fader it is possible to simu-
late a pre-mix via the headphones. In the right
position the master signal is audible, in the left
position the cue signal is audible.
T30 power Status LEd
Illuminated when the controller is turned on, if
voltage is provided.
T31 MIdI Status LEd
Illuminated when MIDI signals are sent.
T32 Master Level LEd Indicator
Optically displays the master output level.
T33 Crossfader
Crossfader between ch.1 and ch.2
5. dEvICE SEttINGS aNd tEStS
There are a few settings and tests which can be carried out directly with Mixage without the need
for a computer. In the following a few points will be explained more thoroughly.
5.1. MIdI CHaNNEL aSSIGNMENt
NOtE!
By default Mixage is configured for MIdI channels 1 or 2. the MIdI channel can be selected via
the switch on the rear side -B40-.
It is possible to connect a further Mixage controller, i.e. for DJ teams. For this purpose it is important
that one Mixage is on MIDI channel 1 and the second Mixage is on MIDI channel 2 (see switch -B40-).
Reloop‘s official mappings are laid-out according to the standard configuration. Therefore changes
are usually unnecessary.
NOtE!
updated and advanced mappings can also be found online. Go to http://www.reloopdj.com/forum
and open the category „Mapping Files“ under „downloads for all reloop products“.
5.2. LEd FuNCtIONaL tESt
Herewith it is possible to check whether all of Mixage‘s LEDs work properly.
To carry out the functional test proceed as follows:
1. Make sure that Mixage is turned off (USB cable has to be disconnected -B39-).
2. Press and hold the left Sync Button -T16- and turn on Mixage by connecting the USB cable -B39-.
3. Now release the Sync Button -T16-.
4. Now all LEDs should be illuminated.
5. In order to finish the test, simply turn off the device by disconnecting the USB cable -B39-.