Reloop NEON - VirtualDJ 8 Operation Guide - Manual (Page 10)

VirtualDJ 8 – Reloop NEON 10
Sampler mode
Press the SAMPLER mode button to set the PADs to Sampler mode.
Each one of the 8 pads triggers a sample
(1 to 8) from the selected Sampler Bank of
VirtualDJ.
The leds of the Pads will automatically get
the assigned color of each sample (dark
when off, bright when playing).
Press the pads to trigger a sample.
Depending on the selected trigger mode,
use SHIFT and the same pads to stop the
sample.
Use the DECK/BANK SEL buttons (1) to select a different Sampler Bank (1 to 4). Banks
greater than 4 can be selected via the VirtualDJ GUI.
Hold SHIFT down and then use these buttons to select the Output channel (1 to 4) for the
Sampler. By default VirtualDJ will output Sampler to all available decks if External mixer
audio configuration is set and to the Master Output in other case. To force Sampler Output to
Master (in case a deck is selected), hold SHIFT down and then press the same Output
Assign button once again (all leds will be on in this case)
Hold the MODE/CENSOR (6) button down and then press any of the Pads to select a
different mode for the Sample. The blue Leds above or below that sample will indicate the
selected mode (Stutter-1
st
led, Hold-2
nd
led, On/off-3
rd
led, Unmute-all 3 leds)
Hold the LOOP/SLIP (7) button down and then press any of the Pads to set a Sample to
Loop or Drop mode. In drop mode, the sample will stop when reached at the end.
The orange leds above or below each sample will indicate the status (On when in Loop
mode)
Notes:
- If the trigger mode or loop mode of a sample is changed, all other samples of the same group
will get the same mode too.
- At the time that this manual is written, the changes are temporary (will be lost if a different
bank is selected). Permanent changes in trigger and loop mode can be obtained from the
Sampler Editor.