Reloop NEON - VirtualDJ 8 Operation Guide - Manual (Page 8)

VirtualDJ 8 – Reloop NEON 8
Each one of the 8 pad offers a different
loop function.
Pad 1 enables/disables Smart Loop. If
enabled VirtualDJ will auto-create a
seamless loop if a manual loop is set.
Pad 2 enables/disables Loop Roll mode.
If enabled, the loops will act temporary
and the track will return to the position it
would have been if the loop was never
triggered.
Pad 3 enables/disables Back Loop mode.
If enabled and a loop is triggered by a
number of beats, the current position will
be set as the end point of the loop.
Pad 4 records this deck to a new Sample. If a loop is enabled, the recorded sample will be
automatically set to Loop and Sync mode (suggested way to quickly create synced samples)
Use Pads 5 and 6 to set a Loop Entry (In) and a Loop Exit (Out) point for manual looping.
While a loop is active, use the same buttons to enable the Loop In Move and Loop Out
Move modes (leds will blink to indicate the mode). When these modes are enabled, you can
fine adjust the Loop In and Loop Out points of the loop, by either using a jogwheel or
SHIFT+LOOP ENC.
Use Pad 7 to either exit or trigger a loop.
Use Pad 8 to repeat the last triggered loop (reloop).
When SHIFT is pressed, the 8 Pads offer 4 Saved Loop slots.
Use Pads 1 to 4 to save a loop to the first
available slot at the current position.
Hold any of the same buttons down for
more than 1 second to delete the last
saved Loop
Use Pads 5 ad 8 to Load and Prepare the
Saved Loops (it will not jump to that point
if the position of the track is before that
point).