Reloop NEON - VirtualDJ 8 Operation Guide - Manual (Page 5)

VirtualDJ 8 – Reloop NEON 5
A. Control buttons
S. SHIFT . Press and hold this button down to access secondary functions of the
Reloop NEON
1. DECK/BANK SELECT .
In Sampler mode (see Sampler mode ), use these buttons to select Sampler Banks 1
to 4.
Hold SHIFT down and then use these buttons to select the Output channel (1 to 4) for
the Sampler. By default VirtualDJ will output Sampler to all available decks if External
mixer audio configuration is set and to the Master Output in other case. To force
Sampler Output to Master (in case a deck is selected), hold SHIFT down and then
press the same Output Assign button once again (all leds will be on in this case)
In all other modes, use these buttons to assign the unit to decks 1 to 4.
2. TRACK ENC. Use the encoder to scroll through files or folders. If focus is on the
Folders list, push the encoder to set the focus to the Songs List. If focus is on the
Songs list, push the encoder to load the selected track to the assigned deck.
Hold SHIFT down and then push the encoder to set the focus to the Folders list.
Hold SHIFT down and then use the encoder to adjust the Master Sampler Volume.
3. PAD MODE SEL. Use these buttons to set the PADS (4) to one of the 8 available Pad
modes (see PADS )
4. PADS. The 8 touch-sensitive Pads offer different functionality, depending on the
selected Pad mode. (see PADS )
They offer touch and after-touch velocity in all modes (selected using
SHIFT+SAMPLER) and RGB leds. The velocity on the Effects mode is always On.
5. LOOP ENC. Turn the encoder anti-clockwise to half the size of the loop and
clockwise to double it. Hold SHIFT down and then use the encoder to move the
triggered loop forward or backwards by half the size of the selected loop..
Push the encoder to trigger the selected loop.
Hold SHIFT down then push the encoder toggle between normal and Roll Loop
mode. If the Loop Roll mode is enabled, the loops will act temporary and the track will
return to the position it would have been if the loop was never triggered.
The same encoder can control the 2
nd parameter of the selected Effects (see Effects
mode )
6. MODE/CENSOR.
In Sampler mode hold this button down and then press any of the Sampler pads to
cycle through the available Trigger modes (see
Sampler mode ).