Reloop NEON - VirtualDJ 8 Operation Guide - Manual (Page 7)

VirtualDJ 8 – Reloop NEON 7
Remix mode
While the Hot Cue mode is selected, press the same HOTCUE mode button again to set the
PADs to Remix mode (led will blink).
Each one of the 8 pads triggers a Remix
point (1 to 8) from the loaded track. Remix
points are pre-assigned when a track is
analyzed (loaded) and usually offer the
Start and End points of a Break.
Remix points can be added/edited/deleted
from the POI Editor of VirtualDJ.
When a Remix point is triggered, the track
will jump to that point, but will also make a
smooth transition, so that the Beat phase is
kept and a seamless jump/mix offered.
Hot Loop mode
Press the HOT LOOP mode button to set the PADs to Hot Loop mode.
Each one of the 8 pad assigns a Hot
Cue Point or returns the track to that
Hot Cue Point, but in both cases, it also
triggers a momentary Loop at that
point.
Hold SHIFT down and then use the
same pads to trigger a toggle (on/off)
loop.
The Loop length can be adjusted by the
LOOP ENC (5).
Manual Loop mode
While the Hot Loop mode is selected, press the same HOT LOOP mode button again to set
the PADs to Manual Loop mode (led will blink).