Reloop TERMINAL MIX 8 - VirtualDJ 8 Operation Guide - Manual (Page 10)

VirtualDJ 8 – Reloop Terminal Mix 8 10
Loop & Loop Roll mode
Press the LOOP mode button to set the PADs to Loop mode.
Each one of the PADs triggers a loop of a
different size as per the image.
Press the same pads to disable the applied
loop or another one to apply a loop of a
different size. The LOOP encoder can be
also used to half/double the size.
Hold SHIFT down and then press one of
the pads to trigger a momentary Loop
Roll of a different size as per the image.
Once the PAD is released the track will
continue to play from the position it would
have been if the Loop Roll was never
triggered.
Manual Loop mode
If the LOOP mode is selected, press again the same Mode button to set the PADs to
Manual LOOP mode (led will blink).
Each one of the 8 pad offers a different
loop function.
Use Pads 1 and 2 to set a Loop Entry (In)
and a Loop Exit (Out) point for manual
looping.
Use Pads 5 and 6 to move the Loop by 1
beat
Use Pads 3 and 4 to save the current loop
to one of the 2 available slots and Pads 7
ad 8 to Load and Prepare the Saved
Loops (it will not jump to that point if the
position of the track is before that point).