Reloop TERMINAL MIX 8 - VirtualDJ 8 Operation Guide - Manual (Page 9)

VirtualDJ 8 – Reloop Terminal Mix 8 9
SHIFT and the same pads to stop the
sample.
If the SAMPLER mode is selected, press again
the same Mode button to receive the Sampler
parameters (led will blink).
Use Pads 1 and 5 to select the previous and
next available Sampler Bank.
Use Pads 4 and 8 to select the next sampler
trigger mode (On/off, Hold, Stutter and
Unmute)
Use Pad 2 to record the deck into a new
Sample.
Use Pad 3 to toggle the Sampler between the
List and Trigger pad view.
HotCues mode
Press the CUE mode button to set the PADs to HOT CUE mode.
Each one of the 8 pad assigns a Hot Cue
Point or returns the track to that Hot Cue
Point.
When a Hot Cue Button is unlit, you can
assign a Hot Cue Point by pressing it at the
desired point in your track. Once it is
assigned, the Hot Cue Button will light up red.
Hold SHIFT and then press a pad to delete its
assigned Hot Cue Point. Red leds will blink if a
HotCue point exists
If the CUE mode is selected, press again the same Mode button to set the PADs to
HOTCUE LOOP mode (led will blink).
Each one of the 8 pad assigns a Hot Cue
Point or returns the track to that Hot Cue
Point, but in both cases, it also triggers a
Loop at that point, while the Pad is pressed
(led will become blue).
Hold SHIFT and then press a pad to delete its
assigned Hot Cue Point. Red leds will blink if a
HotCue point exists