Reloop TERMINAL MIX 8 - VirtualDJ 8 Operation Guide - Manual (Page 7)

VirtualDJ 8 – Reloop Terminal Mix 8 7
15. FX1 ON. Press this button to enable/disable the selected effect of FX Slot 1. Hold
SHIFT down and then press this button, to select the next available effect for FX Slot
1.
16. FX2 ON. Press this button to enable/disable the selected effect of FX Slot 2. Hold
SHIFT down and then press this button, to select the next available effect for FX Slot
2.
17. FX3 ON. Press this button to enable/disable the selected effect of FX Slot 3. Hold
SHIFT down and then press this button, to select the next available effect for FX Slot
3.
18. LOOP ENC. Turn the encoder anti-clockwise to half the size of the loop and
clockwise to double it. Hold SHIFT down and then use the encoder to move the
triggered loop forward or backwards by 1 beat.
Push the encoder to toggle between normal and Roll Loop mode.
19. .LOOP ON. Press this button to trigger a loop of the selected size (toggle function).
When Roll loop mode is selected, the button will apply a temporary (while pressed)
Loop Roll and the track will return to the position it would have been if the Loop was
never triggered.
Hold SHIFT down and then use this button (for at least 4 times) to manually tap the
tempo of the track
20. FX ASSIGN 1. Use the left side button to enable/disable the selected Video
Transition. Use the right side button to enable/disable the selected Master Video
Effect.
21. FX ASSIGN 2. Use the left side button to select the next Video Transition. Use the
right side button to select the next Master Video Effect.
D. PADS
Pads (22) offer 11 different modes,
depending on the PAD MODE buttons (23).
Each of the 4 PAD MODE buttons offers 2
individual modes. Press the same PAD
MODE
button again to access the
additional mode (the LED will blink as an
indication).
3 Dual modes are also offered. Press 2
PAD Mode buttons (from SAMPL, CUE and
LOOP) at the same time to access one of
the dual modes.