Reloop TERMINAL MIX 8 - VirtualDJ 8 Operation Guide - Manual (Page 11)

VirtualDJ 8 – Reloop Terminal Mix 8 11
While SHIFT is pressed use Pads 1 and 2 to repeat the last triggered loop (reloop) and
exit. Use Pads 3 and 4 to delete the saved Loops. Use Pads 7 and 8 to Load (and jump to)
the saved Loops.
HotCue & Sampler dual mode
Press the CUE and the SAMPL mode buttons at the same time to set the PADs to the Hot
Cue & Sampler Dual mode.
In this mode the top 4 PADs assigns a
Hot Cue Point (1 to 4) or returns the track
to that Hot Cue Point.
Hold SHIFT and then press a pad to
delete its assigned Hot Cue Point. Red
leds will blink if a HotCue point exists
The 4 lower PADs will trigger a Sample
(slots 1 to 4) Depending on the selected
trigger mode, use SHIFT and the same
pads to stop the sample.
HotCue & Loop dual mode
Press the CUE and the LOOP mode buttons at the same time to set the PADs to the Hot
Cue & Loop Dual mode.
In this mode the top 4 PADs assigns a Hot
Cue Point (1 to 4) or returns the track to
that Hot Cue Point.
Hold SHIFT and then press a pad to delete
its assigned Hot Cue Point. Red leds will
blink if a HotCue point exists
The 4 lower PADs will trigger a Loop of a
different size (from 1/8 to 1 beat)
Hold SHIFT down and then use the lower 4
PADs to trigger a momentary Loop Roll of
a different size (1/32 to ¼ beats)
Sampler & Loop dual mode
Press the SAMPL and the LOOP mode buttons at the same time to set the PADs to the
Sampler & Loop Dual mode.