SONIQ L60U11A-AU User Manual

Page 19

Advertising
background image

Software Application

Software Application

(1) The software will run automatically on boot-up under the default mode, you can find the

tray-liked icon on the bottom right of the desktop.

4. Software Application

4.1. Running

(2) If you closed this software by accident, you can find "Free Interactive Technology"

through entering"Start"->"All prgrams", and then select" Fitouch" to run the program.
Default mode: You can find the shortcut of Fitouch" on the Desktop, directly double
clicking it will also run the program.

Click “ ” tray icon to display the main menu as shown below:

4.2. Main Menu

Functions are as follows:

(1) Language: Select user interface language.
(2) Calibrate: Calibrate the screen to ensure the touch position

coincide with the actual position on the screen.

(3) Option: Display the basic information of touch screen. User can

configure corresponding parameters to achieve better effect
according to actual demands. Meanwhile, user can control and
check the device through Option.

(4) About: Display information of Fitouch software.
(5) Exit: Close Fitouch software.

Click “Calibrate” and a dialog as below pops up:

4.3. Calibration

There are Custom and Senior two options in the dialog above. If no option is selected,
then the default will be basic mode calibration.
The mode is only applicable to the situation that one touch screen is connected.

Calibrate Mode” includes “TouchPanel” and “TouchBoard”. The difference between

them is that “TouchBoard” supports positioning of non-rectangular display screen,
“TouchPanel” only supports positioning of rectangular display screen. For rectangular
screen of television, please select “TouchPanel”.

Calibrate Location” includes “1” and “2”. “1” represents positioning icon will move in

four corners of the screen; “2” represents positioning icon will move near the central area
of the screen. (Note: “1” is recommended in regular situation.)
After done with selecting, click “Calibrate” and pop up the following interface. Please
touch the center of “ ” with touch pen or your finger. (In the process of positioning,
the touch pen should be hold vertical to touch surface and the pen head should be
coincided with the center of “ ”.

4.3.1. Basic Mode Calibrating

The positioning icon will move to the four corners of the screen, please touch them respectively.

4.3.2. Custom Mode Calibrating

It is custom mode calibration when “Custom” is selected. It supports following two
positioning ways. Two touch screens are required for positioning in custom mode. It not
supports positioning if there is only one screen.
(1) Double Screen Splicing

Double screen splicing refers to dividing the screen into two parts. The screen
displays in two monitors respectively, while the two monitors need to be equipped
with touch screen. In this way, it needs doing positioning respectively, one is on the
left side of the screen, and the other is on the right side of the screen.

(2) Extended Mode

Extended mode refers to extending the screen into two parts: main screen and
expansion screen, which correspond to two pieces of monitors. Similarly, both two
monitors need to be equipped with touch screen. In this way, it does also positioning
twice separately, the first time on the main screen, the second time on the expansion
screen.

35

34

Advertising