SONIQ L60U11A-AU - Manual (Page 20)

It is Senior Calibrating when “Senior” is selected.
In this mode, user can calibrate the screen flexibly based on your own demands.
Should you have any problem when calibrating the screen in this mode, please contact
our company for technical support.
4.3.3. Senior Mode Calibrating
4.3.4. Electronic Key
Electronic key can be calibrated in the
specified area on the screen. Designated
area must be shown on the dialog box to
configure, save and calibrate.
Click “Option” to display the dialog as follow:
4.4. Option
“Basic” shows information of the connected touch screen. Different touch screen
numbers can be chosen when several touch screens are connected, in order to show the
corresponding information of touch screen. In “Basic” dialog box, user can switch touch
mode in “Basic” as following:
1.Single point to Multi-points: Click “Single Point” and pop up a menu, then click “Multi-
Points” to switch to “Multi-Points” touch mode.(Note: When the “Multi-Points in “Feature”
shows “√”, the “multi-Points touch mode can be available.)
2. Multi-Points to Single Point: Click “Multi-Points” to pop up a menu. Then click “Single
Point” to switch to single point touch mode.
4.4.1. Info
For Window 7 OS, if touch screen supports Multi-Points, user can set it to Multi-points
mode to experience the effect of Multi-points touching.
Single Point Mode: Fully substitute the function of mouse. There is no need to run
Fitouch in this mode.
Multi-Points Mode: Enable user to realize Multi-points or multi-user interaction on the
same screen.
“
Feature” displays update information of touch monitor. “
√”
means supporting, “×”
means not supporting.
Multi-touch upgrade: (Must have appropriate authority before upgrade.) Click “×” after
the multi-touch in “Feature”, the dialog box shown as below:
Software Application Software Application
37 36
TS02R02B021B
00003513
TS02R02B021B
00003513
Multi