SONIQ M200 - Manual (Page 3)

3 4
Product set up Product set up
Where to put your radio
It is important that you note and follow the tips on where the radio should
be situated.
* On a flat and stable surface
* Within 1.4 metres of a power socket (if using mains power)
* Where you can fully extend the telescopic aerial
* Away from bright sunlight or heat sources, such as a radiator
* Not in a humid or very damp place such as a bathroom
Setting up
Step 1: Connect the mains power lead into the socket on the back of the
radio (DC IN) and plug the power adaptor into the mains power wall
socket and switch on.
Step 2: Fully extend the radio aerial in a vertical postition to obtain the
maximum signal strength.
Step 3: Slide the power switch on the back of the radio to ON.
‘Welcome to Digital Radio’ will be displayed and your radio will
automatically scans for DAB+ radio stations.
A progress bar will show the progress of the scan, and the number of
stations found will also be displayed.
When the scan ends, your radio will select the first available station
and begin to play. Stations are listed in numerical and then alphabetical
order by default.
Note: The DAB+ radio station list is stored in the memory and the radio
will not scan for stations next time you switch it on.
Step 4: Inserting the batteries (optional). Before installing the batteries
(not included), please ensure that the DAB+ Radio is unplugged from the
mains power supply.
On the bottom of the radio, push in the tab on the battery cover and pull
up to remove it. Insert 4 x 1.5V LR14C-size batteries, make sure that
note the ‘+’ and ‘-’ markings are in the correct way. Replace the battery
cover, making sure it ‘clicks’ shut.
If used continuously on battery power, your radio has an approximate
15 hours of working life when using good quality batteries. When the
battery power is low, an icon will appear in the top right of the display.
Please switch off the radio and replace the batteries.
Note: For battery operation, please disconnect the mains adaptor and
remove the mains power plug from the back of the radio.
* Only use the recommended batteries or those of the same equivalent
* Do not mix old and new batteries or batteries of different types.
* Batteries are to be inserted with the correct polarity.
* The supply terminals are not to be short-circuited.
* Remove the batteries from the radio if the radio will not be used for an
* Do not attempt to recharge non-rechargeable batteries.
* Dispose of old batteries carefully.
* Never throw batteries in a fire or attempt to open the outer casing.
* Batteries are harmful if swallowed, so keep away from young children.
Batteries(battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
CAUTION: Danger of explosion may occur if battery is incorrectly
replaced. Replace only with the same or equivalent type.
Backlit display
If no button being pressed for 10 seconds, the display backlight will dim.
Using headphones
You can connect headphones (not included) to your radio. The headphone
socket can be found on the back of the radio.
Note: Headphones need a 3.5mm stereo plug.
extended period of time.
type.