SONIQ M200 - Manual (Page 5)

7 8
Using your DAB+ radio Using your DAB+ radio
Changing DAB+ stations
1. If the system is not set in DAB+ mode, press the ‘Mode’ button to go
to DAB+ mode.
2. Press the or key to scroll through the stations. The stations are
listed in numerical and then alphabetical order.
3. When the station that you would like to listen to is displayed, press the
‘Enter’ button. “Tuning...” will be displayed whilst your DAB+ radio tunes
to your selected station.
Note: Press and hold the ‘Enter’ button to switch between ‘Auto Enter
On’ and ‘Auto Enter Off’. With Auto Enter setting to “On”, you can change
DAB+ radio stations by just pressing the or buttons. With Auto Enter
setting to "Off", ‘Tuning...’ will be displayed whilst your DAB+ radio tunes
to that radio station.
Station sort
This feature enables you to set the station order in Alphanumeric (Station
name), Ensemble (Station frequency) or Valid Station (current active
stations).
1. Press and hold the ‘Info’ button until ‘Station sort’ is displayed. Press
the ‘Enter’ button.
2. Press the or key to scroll through the options and press ‘Enter’ to
confirm.
Scanning for DAB+ stations
With DAB+ radio, additional stations and services regularly become
available, so it’s a good idea to carry out a manual scan every now and
then to make sure that you have the most up-to-date stations stored
within the memory of your radio. If you have moved your radio to another
location, eg: if you go on holiday, then it’s also a good idea to carry out
a manual scan.
1. If the system is not set in DAB+ mode, press the ‘Mode’ button to go
to DAB+ mode.
2. Press and hold the ‘Info’ button until ‘Station sort’ is displayed.
Press the ‘Info’ button again and ‘Auto Scan’ will be displayed.
3. Press the ‘Enter’ button to start a local search for stations. The
display will change to ‘Scan Services, Quick Scan’. A progress bar
will show the progress of the scan and the number of stations found
during the scan will also be displayed. A local scan takes approximately
10 seconds.
4. If you are using your DAB+ radio outside of Australia, then press and
hold the ‘Enter’ button for 2 seconds (at Step 3) to begin a wider,
national and local scan (Full Scan). A national and local scan takes
minimum 1 minute.
Storing a DAB+ station preset
Your radio can store up to 10 DAB+ stations in its preset memories for
instant access to your favourite stations.
Note: When you store DAB+ radio station presets, please do not
overwrite your FM station presets.
1. Tune your radio to the station that you want to preset (see changing
DAB+ stations, page 7).
2. Press ‘Preset’. The bottom line of the display, showing the number
of the preset location, will flash.
3. Press the or button to scroll through the numbered preset
locations (1-10). Press and hold ‘Preset’ for 2 seconds to store the
station to a preset location. ‘PXX Saved’ where ‘XX’ is the number
of the preset location is displayed.
Note: If there is already an existing DAB+ station stored under a preset,
it will be overwritten when you store a new station.
Tune to a DAB+ preset station
In DAB+ mode:
1. Press ‘Preset’ and use the or button to scroll through the station
presets. Briefly press ‘Preset’ when you select a station. The radio
will tune to that station and begin to play.
Note: If no DAB+ station has been stored under the preset, the display
will revert to the previously selected station.