SONIQ M200 - Manual (Page 8)

14 13
Simple solutions Using the Alarm
Tune off the alarm
Follow steps 1 to 4 and scroll to ‘OFF’. Press ‘Enter’ to select.
Sleep timer
You can set your radio to turn off automatically using the Sleep timer.
You can select from between 15 to 90 minutes for the sleep time.
1. Press and hold the ‘Info’ button until ‘Station Sort’ is displayed.
2. Repeatedly press the ‘Info’ button until ‘Sleep Set’ is displayed.
Press ‘Enter’ to select.
3. Press the or button to scroll to ‘ON’ and press ‘Enter’ to select.
4. Press the or button to scroll to the number of minutes for your
sleep timer. You can choose from 15, 30, 45, 60, 75 or 90 minutes.
Press ‘Enter’ to select. An ‘s’ will be displayed, indicating the
sleep timer has been set.
5. When the sleep time you have set has elapsed, the radio will switch
itself off and the ‘s’ will no longer be displayed.
Turn off the sleep timer
Follow steps 1 to 3 and scroll to ‘OFF’. Press ‘Enter’ to select or simply
switch off the radio.
If you are experiencing problems with your radio, there are some quick
and easy checks that you can do, which may help to solve the problem.
Radio reception is poor
- Please check that the aerial is FULLY extended for the maximum
signal strength and improved reception.
- Try moving your radio to an alternative location to see if the reception
improves. Please remember to scan for DAB+ stations again once you
have moved your radio. See page 8.
- Check that you do not have other electrical equipment too close to
your radio, causing interference.
No sound
- Adjust the volume using the ‘Vol+’ button.
- You have headphones connected. Please remove or use the
headphones to listen to the radio.
- Please check that the mains power lead is connected at the back of
the radio and the mains power wall socket is switched on.
- You may need to re-scan if the station you last listened to is no longer
available. See page 8.
The function buttons do not respond
- Check that the power lead is plugged into the back of the radio and
that the mains adaptor is plugged in and switched on. If you are using
batteries, they may be exhausted and need to be replaced. Slide the
power switch on the back of the radio to ‘On’.
- Turn off the radio, unplug the mains power and remove the batteries.
Leave for 1 minute and then reconnect your radio.
- Try a reset to factory defaults.
1. Press and hold ‘Info’ until ‘Station Sort’ is displayed.
2. Repeatedly press the ‘Info’ button until ‘System Reset’ is displayed.
Press ‘Enter’ to select . Your radio will now return to its original
factory settings and the preset radio stations will be deleted.