SONIQ MC9 - Manual (Page 10)

9
2. To stop playback, press the PLAY/PAUSE button. The elapsed time display starts to blink.
3. To resume playback, press the PLAY/PAUSE button once again.
4. To definitively stop playback, press the STOP/BAND button.
Selecting a different track during playback
1. Press the TUNING/SKIP/SEARCH (UP or DOWN) button on the system (or the remote control), until
the desired track number appears on the display.
2. Press the PLAY/PAUSE button to start playback.
Repeat play
1. While playing a CD, if you would like to repeat only one track, press the REPEAT/MEMORY UP
button on the system (or the remote control) once: the "REPEAT" indicator comes on and blinks.
2. If you would like to repeat all of the tracks on the disc, press the REPEAT/MEMORY UP button twice:
the "REPEAT" indicator comes on but does not blink.
3. To disable the repeat function, press the STOP/BAND button or press the REPEAT/MEMORY UP
button until the "REPEAT" indicator is cleared from the display.
Random play
1. Press the RANDOM button once and the "RANDOM" indicator will come on.
2. The tracks will be read in random order.
3. Press the STOP/BAND button to disable the random play mode.
INTRO PLAY(accessible from the remote control)
1. During the stop condition, pressing the INTRO button to start the intro playing.
After that the 10 seconds of each song will be played.
2. If the INTRO button is pressed again, the CD will change to the normal playing mode.
Stop play
1. Press the STOP/BAND button if you wish to stop playback. The number of tracks that can be played
from the disc are displayed.
2. Open the CD door to remove the CD.
Programming the CD player
By programming the CD player, you can play up to 20 tracks in the order of your choice (this is only
possible when the CD player is stopped).
1. Place the disc into the compartment prior to programming. Press the MEMORY/CLK. ADJ button.
2. The display shows MEMORY TRACK and P-01.
3. Press the TUNING/SKIP/SEARCH (UP or DOWN) button to select the first track to be
programmed.
4. Once the desired track appears on the display, press the MEMORY/CLK. ADJ button once again.
5. The display will show MEMORY TRACK and P-02.
6. Repeat this procedure to select other tracks on the disc to be programmed in memory.
7. In radio MODE, when the frequency is displayed, this button is used to activate the memory save
mode for five seconds.
Clearing a program
To clear a program:Press the MEMORY/CLK. ADJ button and then the STOP/BAND button in stop
mode or power down the system or open the CD door.
Note: If you create a new program, the current program will be deleted.MUTE (accessible from the
remote control)
1. If you press the MUTE button on the remote control, the corresponding indicator will come on
and the audio output will be temporarily cut.
2. Press the MUTE button again: the indicator goes off and the audio output resumes normally.