SONIQ MC9 - Manual (Page 8)

7
Programming presets
You can also preset the stations of your choice and program up to ten AM stations and ten FM stations in
the system's memory. To store radio stations:
1. Press the STOP/BAND button on the system (or the remote control) to toggle between AM and FM
bands to make your selection.
2. Tune the receiver to the desired station.
3. Press the MEMORY/CLK. ADJ button.
4. Press the REPEAT/MEMORY UP button until the desired preset number is displayed.
5. Press the MEMORY/CLK. ADJ button once again to confirm your selection.
6. To program other stations in memory, repeat operations 2 to 5 above.
7. To change the station presets, repeat operations 2 to 5 above.
Notes:
1. Storing a new station in a previously used memory location will clear the station previously stored in
this location.
2. Any power break or unplugging the mains power cord will clear all of the presets stored in memory.
Perform the station preset procedures once again to store them in memory.
Selecting preset stations
1. Press the STOP/BAND button to select the required frequency band.
2. Press the REPEAT/MEMORY UP button to select the required preset number.
3. The memory location where the station is stored is displayed along with the corresponding radio
frequency.
FM antenna
An FM wire antenna is provided for better FM reception.
USING THE CASSETTE DECKPlaying a cassette
To play a cassette, press the button to open the cassette door.
Before playing, take up any slack in the cassette tape. To do this, use a pencil or pen. Simply insert the
pencil or pen through the center of the reel and turn it in order to take up any slack. Press the CASS.
STOP/EJECT button to open the cassette door.Insert the cassette into the compartment with the
opening in which the tape is exposed facing down and the full reel to the left, press the cassette all the
way in and close up the door. Always avoid touching the tape surface. Select "TAPE" on the function
selector and press the PLAY button. To stop play,
press the CASS. STOP/EJECT button again. To eject the cassette, press the CASS. STOP/EJECT
button once again.
Recording programs from the radio
Move the function selector to RADIO, select AM or FM by pressing the STOP/BAND button and tune the
receiver to the desired station (refer to the heading on using the radio). Insert the cassette into its
compartment and press the RECORD button. Press the CASS. STOP/EJECT button to stop recording.
You can use the CASS. PAUSE button to stop recording for short periods. Press the CASSETTE F.FWD
button to move to fast forward. Press the CASSETTE REWIND button to quickly rewind the tape.
Recording a CD
Move the function selector to CD. Select the tracks to be recorded. Insert a cassette into the
compartment and press the CASS. RECORD button. Press the CASS. STOP/EJECT button to stop
recording.
Listening to music using headphones
The system includes a headphone jack. To use the headphones, press the jack plug on the headphones
all the way into the jack.