SONIQ MC9 - Manual (Page 7)

6
TIMER SETTING
1. Once the clock has been set, press the TIMER button and hold it down for three seconds: "TIMER" is
shown on the display and it blinks.
2. In 24 hour display mode, "0:00" is displayed.
3. Press the MEMORY/C-ADJ button and hold it down for three seconds: the hour digits start to blink.
Set them by pressing the TUNING/SKIP/SEARCH (UP or DOWN) buttons.
4. Press the MEMORY/C-ADJ button once again: the minute digits start to blink. Set them by pressing
the TUNING/SKIP/SEARCH(UP or DOWN) buttons.
5. Press the REPEAT/MEMORY UP button to set the programmed start time (TIMER ON).
6. At the programmed time, the system will automatically switch on and play music and the "TIMER"
indication will blink.
7.
One hour later, the system will switch off automatically.
SETTING THE SLEEP FUNCTION
1. If you would like to fall asleep listening to music, press the TIME/SLEEP button on the system
(or on the remote control).
2. You can set the Sleep function so that the Tuner or CD player continues to play for 90, 80, 70
minutes, or less, down to ten minutes, before the system automatically switches off.
90 80 70 60 50 40 30 20 10
SNOOZE FUNCTION (accessible by remote control)
1. To use the Snooze alarm function in the TIMER ON mode, press the SNOOZE button: the system
switches to STANDBY mode and "SNOOZE" is shown on the display.
2. Five minutes later, the system automatically starts, changing to the TIMER ON mode and starts to
play music, "TIMER" blinks on the display.
3. The system automatically switches off one hour later.
RADIO OPERATION
Press the TUNER button on the system (or on the remote control) to select the Tuner function.
1. Press the TUNER button: the frequency band is displayed.
2. Select the desired frequency band by pressing the STOP/BAND button.
Manual tuning
1. To tune in to weak stations, perform a manual search by continually pressing the
TUNING/SKIP/SEARCH (UP or DOWN) buttons until the correct frequency is displayed or until good
quality reception is obtained.
2. If you would like to select an FM stereo station, place the FM MODE selector in STEREO mode
First.
Once you have tuned into an FM stereo station, the
indicator appears on the display
and you can listen to FM stereo programs. (To select the "FM MODE", act on the "BEAT CUT/FM
MONO/STEREO" switch located on the back of the system).
3. If you place the FM MODE selector in the MONO position, the FM STEREO indicator goes out and
the system returns to FM MONO mode program reception.
Automatic tuning
1. Press the TUNING/SKIP/SEARCH UP or DOWN) buttons for one second or more, then release the
button. The tuner will automatically search for the first station broadcasting a sufficiently strong signal.
2. Repeat the above procedure if you would like to select another station.