SONIQ PB100 - Manual (Page 14)

14
Playing a Blu-ray Disc or DVD
1. Slide the CHARGE/OFF/ON switch to the ON position.
See CUSTOMIZING THE DVD FUNCTION SETTINGS before proceeding to step 2.
2. Push to open the disc door.
3. Hold the disc by its edge and gently push it onto the spindle, with the label side facing the front,
until you hear a “click”.
4. Push the disc door gently to close it. It takes a short while for your unit to load the disc. After
loading, for most discs, the unit will automatically take you to the main menu or start playing. If
the unit does not automatically start playing the disc, press the PLAY button or OK button for
a Blu-ray disc.
Note:
Normal reading time for a Blu-Ray disc is approximately 30 seconds (it will be depended on different
discs). The reading time may be more than 30 seconds for some of the discs. In addition, the
reading time may be a little bit longer if use the "bookmark" function (option from a blu-ray disc).
Pausing Playback (Still Mode)
Press the (PAUSE) STEP button to pause. To resume normal playback, press the PLAY button.
Each time you press the (PAUSE) STEP button, the picture advances one frame on disc .
Stopping Playback
To stop playback, press the STOP button. To resume playback, press the PLAY button.
Depending on the disc, playback starts where it stopped or at the beginning of the disc.
If you press the STOP button twice, the unit’s memory will be cleared and pressing the PLAY
button will reset the disc to the beginning.
Skipping to a Different Track
• Press the SKIP button to go back to previous titles/chapters/tracks.
• Press the SKIP button to advance titles/chapters/tracks.
• For an audio CD, use the number buttons on the remote control to go directly to the desired track
number.
Zooming into an image
While a disc is playing, press the ZOOM button to enlarge the image in serveral levels.
• While an image is zoomed, you can use the , , or CURSOR button to shift the view and
display the part you want.
• To return to normal view, press the ZOOM button repeatedly until "OFF" shows. The screen will
return to normal.
• When you reach the edge of the image, the display will not shift anymore in the direction.
This owner’s manual explains the basic
instructions for operating this unit. Some
discs are produced in a manner that allows
specific or limited operation during playback.
Therefore, this unit may not respond to
all operating commands. THIS IS NOT A
DEFECT. Please refer to the instructions
accompanying the specific disc in question for
more information about the options available
on that disc.
“ ” may appear on the screen during
operation. A “ ” means that the desired
operation is not permitted by the unit or disc.
PLAYING A BLU-RAY DISC OR DVD