Getting started, Using the remote control – SONIQ QV193LTI User Manual

Page 12

Advertising
background image

- 12 -

USING THE REMOTE CONTROL

When using the remote control, aim it at remote sensor on the unit. If there is an object between the

remote control and the signal remote sensor on the unit, the unit may no operate.

• Point the remote control at the REMOTE SENSOR located on the unit.

• When using this unit in a very brightly lit area, the infrared REMOTE CONTROL SENSOR may

not work properly.

• The recommended effective distance for using the remote control is about 16 feet (5 metres).

TO CHANGE THE REMOTE CONTROL BATTERY

BATTERY REPLACEMENT

You will need to install the supplied batteries into the remote control to make it operate following the

instruction below.

When the batteries become weak, the operating distance of the remote control will be greatly reduced

and you will need to replace the batteries.

Notes on Using Batteries:

The use of the wrong type of batteries may cause chemical leaks and/or explosion. Please note the

following:

• Always ensure that the batteries are inserted with the positive and negative terminals in the correct

direction as shown in the battery compartment.

• Different types of batteries have different characteristics. Do not mix different types.

• Do not mix old and new batteries. Mixing old and new batteries will shorten battery life and/or cause

chemical leaks from the old batteries.

• When batteries fail to function, replace them immediately.

• Chemicals which leak from batteries may cause skin irritation. If any chemical matter seeps out of

the batteries, wipe it up immediately using a dry cloth.

• Due to varying storage conditions, the battery lift for the batteries included with your unit may be

shorten. If the remote control is not used for a long period of time, remove the batteries.

• The battery shall not be exposed to excessive heat such as sunshine, fire or the like.

CAUTION:
Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent

type.

Getting Started

1. Open the lid of the remote control battery

compartment.

2. Insert two size-AAA batteries.

Ensure that the batteries are inserted with the

positive and negative terminals in the correct

direction corresponding to the (+) and (-) marks

in the battery compartment.

Advertising