TeachLogic VoiceLink Plus - Manual (Page 15)

Optional:
Two Additional Speakers
9
installing SP-2000 wall mount speakers
•
First observe the shape of the room: ceiling height,
door locations, windows, mounting surface, and
seating area
•
Ordinary installation would be to locate the
speakers on each side wall approximately even
with the front row of listeners
•
Mount the speakers 6–7 feet above the floor
•
Install the mounting brackets in the vertical (up/
down) orientation
•
Mount brackets using the appropriate hardware
•
Insert speaker with the tweeter in upper position
•
Secure speaker in bracket with the hand fasteners
•
Orient each speaker toward the center of that half
of the listening area
•
Strip speaker cable ends ½” and connect to
speaker
•
Observe speaker polarity: Connect (+) wire
(with printed writing) to (+) terminal and (-) wire
(unprinted & textured) to the (-) terminal
•
Route speaker cable to the receiver/amplifier in a
safe, least visible, tidy manner
VoiceLink I
Receiver
Front of Room
Wall Speakers
Ceiling Sensor
VoiceLink I
Receiver
Front of Room
Wall Speakers
Ceiling Sensor
final connection of the system
With receiver/amplifier located, speaker and sensor
cables neatly routed, we are ready to complete the
installation.
•
Cut the speaker wire to the appropriate length
•
Strip about 3 /
8
” off the end of each speaker
wire.
•
Twist the wire and if you have a soldering iron,
tin the wire ends
•
Unplug the phoenix connector, insert (+) wire
(with printed writing) into either outside (+)
terminal. Plug the other (-) wire into center (-).
•
Tighten set screws.
•
Repeat for other pair and insert plug firmly into
speaker receptacle
•
Plug power supply into AC outlet