TeachLogic VoiceLink Plus - Manual (Page 20)

owner’s manual
14
projector system setup
•
With sensor installed, connect it to VoiceLink Plus
•
Connect VoiceLink Plus into AC power and locate
it near projector
•
Connect an audio cable with 3.5mm connectors
from projector audio output to VoiceLink Plus
input (front panel)
•
Connect the speaker outputs to installed
speakers
•
Turn “on” VoiceLink Plus and Video Projector
•
Set “AUX IN” control on VoiceLink Plus to 2
o’clock position
•
With microphone turned “on”, speak and adjust
microphone volume using “MIC” volume control
on VoiceLink Plus
•
With an Auxiliary program turned “on” and
plugged into the projector, adjust the auxiliary
volume with the remote control
•
Once auxiliary volume is optimized, readjust
microphone volume using “MIC” volume control
•
System is now ready to use with remote control
of AUX inputs and consistent Mic volume (Mic
volume does not change with remote volume
control)
Microphone volume is
not affected by the remote
control of the auxiliary
inputs.
note
How to Interface VoiceLink Plus with a Video Projector
and incorporate the Projector’s Remote Control
VoiceLink
AUDIO OUT
REMOTE
SENSOR
AUDIO
IN 1
AUDIO
IN 2
AUDIO
IN 3
Infrared Transmitter
”Sapphire“ IRT-55
Speakers Speakers
Projector
Remote Control
Video Projector
POWER
INFRARED MIC AUX IN
VoiceLink Plus
MP3 Player
Computer
DVD Player
Ceiling Sensor