TeachLogic VoiceLink Plus - Manual (Page 18)

2
12
system operation
•
Set volume control of receiver and microphone to
“Minimum”
•
Turn power “on”, push button on left side
•
Red LED indicates power “on”
•
Check power to sensor, “Yellow” LED on corner
sensor, “Green” on ceiling sensor
•
Rotate “CH A” volume control to about mid scale
•
Turn “on” microphone, Green LED
•
Verify IR transmission, “Orange” LED adjacent to
volume control
•
While standing either under or in front of a
speaker, slowly increase the volume of the
microphone while talking into microphone
•
Adjust until you begin to get feedback (squealing)
•
Reduce volume to stable non-ringing condition
•
While talking into microphone, walk around
the room verifying continuous connectivity
throughout the room
•
Hopefully the test was 100% satisfactory, this
competes the vocal test of the system
Test of the auxiliary input using an external audio
source i.e. iPod, DVD, or computer
•
With receiver turned “on”, set “AUX IN” volume
to minimum
•
Plug in an auxiliary source using an audio cable
with a 3.5mm plug
•
Turn “on” your auxiliary source i.e. iPod, DVD,
Computer
•
Observe signal presence indicator, “Orange”
LED
•
Increase “AUX” volume to about mid scale
•
Slowly increase volume or gain of auxiliary source
to desired volume
operating the system
We will test of the system with the wireless microphone/transmitter purchased with the system
and an external auxiliary source i.e., an iPod™, computer, or DVD player.
VoiceLink