Tweco CutMaster 10mm-12mm - Manual (Page 25)

CUTMASTER 10MM, 12MM
Manual 0-5197AC 4-3 OPERATION
B. Torch Connection
Check that the torch is properly connected.
C. Check Primary Input Power Source
1. Check the power source for proper input voltage. Make sure the input power source meets the power require-
ments for the unit per Section "2.05 Power Source Specifi cations" on page 2-2.
2. Connect the input power cable (or CLOSE the main disconnect switch) to supply power to the system.
D. Gas Selection
Ensure gas source meets requirements listed in Section "H. Gas Requirements" on page 2T-1. Check connec-
tions and turn gas supply ON.
E. Connect Work Cable
Clamp the work cable to the workpiece or cutting table. The area must be free from oil, paint and rust. Connect
only to the main part of the workpiece; do not connect to the part to be cut off.
Art # A-03387
Figure 4-4 - Work Cable Connection
F. Power ON
Place the Power Source ON/OFF switch to the ON (I) position. Power indicator turns ON.
Art# A-10225
Air Inlet, 1/4” NPT
On/Off
Switch
Power Cord
Figure 4-5 - Rear Panel with ON/OFF Switch
A
30
20
40
Art# A-10219
Power indicator
Figure 4-6 - Front Panel with Power ON/OFF Indicator