Tweco A40 CutMaster User Manual
Operating manual, Cutmaster, Automated plasma cutting system
Advertising
Table of contents
Document Outline
- SECTION 1: GENERAL INFORMATION
- SECTION 2 SYSTEM: INTRODUCTION
- SECTION 2 TORCH: INTRODUCTION
- SECTION 3 SYSTEM: INSTALLATION
- SECTION 3 TORCH: INSTALLATION
- SECTION 4 SYSTEM: OPERATION
- SECTION 4 TORCH:
OPERATION
- 4T.01 Machine and Automated Torch Operation
- 4T.02 Automation Torch Parts Selection
- 4T.03 Machine and Hand Torch Parts Selection
- 4T.04 Cut Quality
- 4T.05 General Cutting Information
- 4T.06 Hand Torch Operation
- 4T.07 Gouging
- 4T.08 Recommended Cutting Speeds for Machine and Automated Torches With Exposed Tip
- 4T.09 Recommended Cutting Speeds for Machine and Automated Torches With Shielded Tip
- PATENT INFORMATION
- SECTION 5 SYSTEM: SERVICE
- SECTION 5 TORCH: SERVICE
- SECTION 6:
PARTS LISTS
- 6.01 Introduction
- 6.02 Ordering Information
- 6.03 Power Supply Replacement
- 6.04 Replacement Power Supply Parts
- 6.05 Options and Accessories
- 6.06 Torch Replacement Parts SL100SV Torch (with Solenoid on Mounting Tube)
- 6.07 Torch Consumable Parts (SL100 SV) Automation
- 6.08 Torch Consumable Parts Manual (SL60)Torch
- 6.09 Replacement Parts for Hand Torch
- APPENDIX 1: SEQUENCE OF OPERATION (BLOCK DIAGRAM)
- APPENDIX 2: DATA TAG INFORMATION
- APPENDIX 3: TORCH PIN - OUT DIAGRAMS
- APPENDIX 4: TORCH CONNECTION DIAGRAMS
- APPENDIX 5: SYSTEM SCHEMATIC, 208/460V UNITS
- APPENDIX 6: SYSTEM SCHEMATIC, 400V/600V UNITS
- APPENDIX 7: RAW ARC VOLTAGE
- APPENDIX 8: PUBLICATION HISTORY