Tweco 35A CutSkill - Manual (Page 15)

cutskill 35A
Manual 0-5104 3-1 INSTALLATION
SECTION 3:
INSTALLATION
3.01 Unpacking
1. Use the packing lists to identify and account for each item.
A. Contents List
Description Quantity
Power source 1
10 ft (3 m) power input cable (fitted) 1
SL60 1 Torch (fitted) 1
Work cable and clamp (fitted) 1
Carry case 1
40A Drag Tip (Located in power source handle) 2
Electrode (Located in power source handle) 1
Gas Regulator 1
Operating Manual 1
2. Inspect each item for possible shipping damage. If damage is evident, contact your distributor and / or ship-
ping company before proceeding with the installation.
3. Record Power Supply and Torch model and serial numbers, purchase date and vendor name, in the information
block at the front of this manual.
3.02 Lifting Options
The Power Supply includes a handle for hand lifting only. Be sure unit is lifted and transported safely and
securely.
!
WARNING
Do not touch live electrical parts.
Disconnect input power cord before moving unit.
FALLING EQUIPMENT can cause serious personal injury and can damage equipment.
HANDLE is not for mechanical lifting.
• Only persons of adequate physical strength should lift the unit.
• Lift unit by the handle, using two hands. Do not use straps for lifting.
• Use optional cart or similar device of adequate capacity to move unit.
• Place unit on a proper skid and secure in place before transporting with a fork lift or other vehicle.
3.03 Primary Input Power Connections
CAUTION
Check your power source for correct voltage before plugging in or connecting the unit. The primary
power source, fuse, and any extension cords used must conform to local electrical code and the rec-
ommended circuit protection and wiring requirements as specified in Section 2.