Tweco SC11 User Manual
Page 16
INTRODUCTION & DESCRIPTION
2-2
Manual 0-2556
2. Input Power
48 vdc supplied from the Plasma Cutting Power Sup-
ply or an external 48 volt power source
3. Front Panel Controls
MODE, LIFTER SPEED, TORCH, ARC VOLTS,
PIERCE HT, PIERCE DELAY, and END OF CUT RE-
TRACT
4. Front Panel Indicators
Arc Volts Display, PLASMA ON, AUTO HT, FIND
HT, HI, LO, T.H.C. ACTIVE, UP, and DN indicators
5. Rear Panel Connections
Connections for MOTOR, PLASMA, EXTERNAL
POWER, CNC, and CNC Cable Strain Relief
6. Dimensions (H x W x L)
2.62 x 12.12 x 10 inches (66 x 308 x 254 mm)
7. Weight
5 lbs (2.5 kg)
B. Lifter Motor
The following applies to the Lifter Motor Assembly only.
1. Dimensions (H x W x D)
29 x 10 x 8 inches (737 x 254 x 203 mm)
Refer to Appendix 7 for detailed dimensions.
2. Weight (Approximately)
20 lbs (9.07 kg)