Tweco SC11 - Manual (Page 18)

INSTALLATION PROCEDURES 3-2 Manual 0-2556
The Standoff Control Assembly and external cable instal-
lation is the same for all systems.
3.05 Mounting Bracket Assembly
Installation
The Mounting Bracket Assembly is used to mount the
Standoff Control Assembly and must be installed in a suit-
able location where it is easily accessable to the system
operator. The unit can be mounted on top of or under-
neath a mounting surface.
Install the Mounting Bracket Assembly per the following
procedure:
1. Select the mounting surface for the Mounting Bracket.
2. Mount the bracket to the surface either on top of or
underneath the surface using four 1/4" bolts (not sup-
plied). It is recommended to use at least four bolts to
mount the bracket but a minimum of two are required.
NOTE
There are seven holes provided in the Mounting
Bracket. Use any four holes that are convenient
for the application.
1/4" Mounting Bolts
(Not Supplied)
Mounting Holes
(Seven Places)
A-00671
Figure 3-1 Bracket Mounting On Top Of Surface
A-00672 1/4" Mounting Bolts
(Not Supplied)
Mounting Holes
(Seven Places)
Figure 3-2 Bracket Mounting Underneath Surface
3.06 Standoff Control Assembly
Installation
Mount the Standoff Control Assembly per the following
procedure:
1. Install the Mounting Bracket per Section 3.05.
2. Insert two of the #10-32 x 3/8" hex head bolts into the
slots on each side of the Standoff Control unit. The
slot prevents the bolts from turning when the knobs
are installed.
Slot
Hex Head Bolt
#10-32 x 3/8"
Knob
A-00688
UP
DN
TORCH TORCH
Figure 3-3 Bolt Installation
3. Set the Standoff Control unit into the Mounting
Bracket being sure the four bolts are in the mounting
slots.