Tweco 200 XT Auto-Cut 380V - Manual (Page 65)

Right Side
Cut Angle
Left Side
Cut Angle
A-00512
Scrap
Clockwise
Counter-
Clockwise
Art # A-04182
Workpiece
Scrap
Swirl Effect on Side Characteristics Of Cut
To make a square - edged cut along an inside diameter of a circle, the torch should move counterclockwise
around the circle. To keep the square edge along an outside diameter cut, the torch should travel in a clock-
wise direction.
Underwater Cutting
Cutting on a water table either underwater or with the water touching the plate or with a water muffler
system is not recommended. If a water table is used the water level must be a minimum of 4 inches from
the bottom of the plate. Failure to follow this recommendation could result in poor cut quality and short
consumable parts life.
Ohmic Sensing
Ohmic height sensing is not recommended with water shield. Water on the plate interferes electrically with
the ohmic sensing circuit.