Tweco Auto Darkening Welding Helmet - Manual (Page 22)

OPERATION AUTO-DARKENING WELDING HELMET
3-1 Manual 0-5045
SECTION 3:
OPERATION
4. Stop Angle Adjustment
Art # A-08591_AB
Loosen Before Adjusting
There are 3 stop positions available (as pictured) to adjust
the angle from the welders eyes to the Filter lens.
5. Helmet Tilt Position
Art # A-08592
The Helmet is designed to be tilted and fixed into position
whilst not welding. Loosen the adjustment knobs located
on either side of the helmet, once in desired position
tighten adjustment knobs to fix into place.
3.01 Harness Adjustment
Prior to use, the Welding Helmet must be adjusted for maximum comfort and protection. The Helmet should be adjusted
such that it is effectively positioned over the eyes and face to ensure adequate protection and comfort whilst welding.
Please refer to the Harness adjustment instructions below.
1. Top Head Band
Art # A-08588
To adjust the top of Head Band move the Head Band in
the direction of either arrow (as pictured) to align the
centre of the harness with centre of the Filter Lens viewing
window.
2. Back of Head Band
Art # A-08589
To adjust the back of Head Band push down the Knob and
turn to the left or right to adjust to desired size.
3. Distance of Harness from Filter Lens
Art # A-08590
There are 3 positions possible that the Harness can be set
upon to achieve the desired distance between the welders
eyes and the Filter Lens.