Tweco 2460 Heavy Duty CC CV Control Wire Feeder - Manual (Page 36)

NOTE: Blow dirt and foreign matter out of
the Brush Box with compressed air of not
more than 25 psi (172 kPa) pressure.
4. Install new brushes if necessary. Reassemble
the unit in reverse order of the dismantling proce-
dure.
Stature Motor Brush Inspection and Installation —
See Figure 8.
1. Remove Brush Cap from the End Cap using a
screwdriver. As the cap is removed, the spring on
the Brush Pigtail will pop up out of the hole.
NOTE: Observe the direction which the
spring bends in order to reinstall the
brush in the same position, for best fit to
the motor commutator.
2. Lift the Brush/Spring out of the Brush Box.
3. Inspect Brush, check dimensions, blow out the
Brush Box with compressed air (see NOTE above).
4. Install new Brush/Spring, if necessary, and
screw the Brush Cap into the threaded hole.
5. Install the feedhead assembly into the Control
Box in reverse order to that in Feedhead Mainte-
nance, paragraph 1 and 2, above.
Figure 8
Figure 7
TIP-219
FEEDHEAD ASSEMBLY NO. 376799A-1, -2, -3, -4
Page 6 December 1, 1997 Revised